NX-200s/300s

NEXEDGE® VHF/UHF Digital & FM Portable Radios nx-200s/300s

General Features

5 W (136-174 MHz) Models
5 W (400-470 MHz) Models
Meets ETSI EN Standards
64 CH-GID / 4 Zones
Transmit / Busy / Call Alert / Warn LED
On / Off Volume Knob
16-Position Mechanical Selector
2 Side PF Keys
Emergency / AUX Key
500 mW Speaker Audio
VOX Ready
Emergency Call Features
Emergency Man-Down Option
Lone Worker
Easy Option Port
Special Alert Tone Patterns
Time Out Timer
Busy Channel Lockout
LED Battery Status Indicator
Low Battery Alert
Battery Saver
Weather-sealed ACC Connector
MIL-Spec Speaker Mic Options
KMC-38GPS Speaker Mic Option
KPG-111D Windows® FPU*1
Flash Firmware Upgrading
MIL-STD-810 C/D/E/F
IP54/55 Water & Dust Intrusion
PC Serial Interface
VGS-1 Voice Guide / GPS Data Storage Option
Transparent Data Mode*2

Digital-General

NXDN® Digital Air Interface
AMBE+2™ VOCODER
6.25 & 12.5 kHz Channels
Over-the-Air Alias (TX)
Emergency Call
All Group Call
Status Messaging*2 *3
Remote Stun / Kill*2
Remote Check*2
Short & Long Data Messages*2
GPS Location with Voice*2
NXDN® Scrambler Included

Digital-Conventional Mode

64 Radio Access Numbers (RAN)
Individual & Group Selective Call*

Digital-Trunkking Mode

Individual Private Call (RX / Talkback only)
Group Call
Broadcast Call
Transmission Trunked Mode*5
Message Trunked Mode*5
Call Queuing with Priority*5
Late Entry (UID & GID)*5
4 Priority Monitor ID's*5
Remote Group Add*2
Failsoft Mode*5

Multi-Site IP Network Compatible

60,000 GIDs / UIDs
Wide Area Group Call
Auto Roaming Registration
Group Registration

SCAN

Single / Multi-Zone Scan
List Scan
Dual Priority Scan (Conventional)

FM Modes-General

25, 20 & 12.5 kHz Channels
FleetSync® / II*4
DTMF Encode / Decode*4
Companded Audio
- Voice Inversion Scrambler
- ANI Board Control

FM Conventional Zones

QT / DQT
Two-Tone Decode
Single / Two-Tone Encode*3
Call Key 1-6

FM LTR ® Trunked Zones

KENWOOD LTR® Features

FleetSync ® / II (FM)*4

PTT ID Digital ANI
Selective Call & Group Call*4
Status Messaging*2 *3
Emergency Status
Short Text Messages*2
Power On / Off Status Messages*2
Send GPS (KMC-38GPS)*2
PTT ID & Emergency GPS Reporting*2
Status Message Block GPS Reporting*2


  • *1 The KPG-111D must be version 2.00 or later.
  • *2 Requires NX subscriber unit PC Serial Interface compatible software application(e.g KENWOOD AVL & Dispatch Messaging software) or hardware (e.g. console).
  • *3 Pre-programmed key operation.
  • *4 Some screen/key-based functions are not available on the NX-200S/300S.
  • *5 These trunked features are primarily system programming and operational dependent. Priority monitor also requires NX subscriber settings.