| TK-2360 | TK-3260 | |
|---|---|---|
| GENERAL | ||
| Frequency Range Type 1 Type 2 |
136 ~ 174 MHz - |
- 400 ~ 470 MHz |
| Number of Channels | Max.16 | |
| Channel spacing Wide / Narrow |
25, 30 kHz / 12.5, 15 kHz |
25 kHz / 12.5 kHz |
| Battery Voltage | 7.5 V DC ± 20% | |
| Battery Life (5-5-90 duty cycle, save off) with KNB-55L (1480 mAh) with KNB-56N (1400 mAh) with KNB-57L (2000 mAh) | Approx. 9 hours Approx. 9 hours Approx. 13 hours | |
| Operating Temperature Range | -30°C to +60°C (-10°C ~ +60°C when KNB-55L / 57L in use) |
|
| Frequency Stability | ±2.5 ppm (-30°C ~ +60°C) | |
| Antenna impedance | 50 Ω | |
| Channel Frequency Spread | 38 MHz | 70 MHz |
| Dimensions (W x H x D), Projections not included Radio Only with KNB-55L with KNB-56N with KNB-57L |
56.0 x 103.7 x 14.0 mm 56.0 x 103.7 x 29.1 mm 56.0 x 103.7 x 33.8 mm 56.0 x 103.7 x 30.1 mm |
|
| Weight (net) Radio Only with KNB-55L with KNB-56N with KNB-57L | 163 g 270 g 380 g 305 g | |
| FCC ID Type 1 Type 2 |
ALH415000 - |
- ALH415101 |
| RECEIVER | ||
| Sensitivity (12 dB SINAD) Wide / Narrow |
0.25 µV / 0.28 µV |
|
| Selectivity Wide / Narrow |
70 dB / 63 dB |
|
| Intermodulation Distortion Wide / Narrow |
68 dB / 68 dB |
|
| Spurious Response | 70 dB | |
| Spurious Response Rejection (Analogue) | 75 dB | |
| Audio Distortion | Less than 5% | |
| Audio Output | 500 mW / 8 Ω | |
| TRANSMITTER | ||
| RF Power Output High / Low | 5 W / 1 W |
|
| Spurious Response | 70 dB | |
| Type of Emission Wide / Narrow |
16K0F3E / 11K0F3E |
|
| FM HUM & Noise Wide / Narrow |
45 dB / 43 dB |
|
| Modulation Distortion | Less than 5 % | |
Measurements made per TIA/EIA 603 and specifications shown are typical.
KENWOOD follows a policy of countinuous advancement in development.
For this reason specifications may be changed without notice.
FleetSync® is a registered trademark of KENWOOD Corporation.
| Standard | MIL 810C Methods/Procedures |
MIL 810D Methods/Procedures |
MIL 810E Methods/Procedures |
MIL 810F Methods/Procedures |
|---|---|---|---|---|
| Low Pressure | 500.1/Procedure I | 500.2/Procedure I, II | 500.3/Procedure I, II | 500.4/Procedure I, II |
| High Temperature | 501.1/Procedure I, II | 501.2/Procedure I, II | 501.3/Procedure I, II | 501.4/Procedure I, II |
| Low Temperature | 502.1/Procedure I | 502.2/Procedure I, II | 502.3/Procedure I, II | 502.4/Procedure I, II |
| Temperature Shock | 503.1/Procedure I | 503.2/Procedure I | 503.3/Procedure I | 503.4/Procedure I, II |
| Solar Radiation | 505.1/Procedure I | 505.2/Procedure I | 505.3/Procedure I | 505.4/Procedure I |
| Rain | 506.1/Procedure I, II | 506.2/Procedure I, II | 506.3/Procedure I, II | 506.4/Procedure I, III |
| Humidity | 507.1/Procedure I, II | 507.2/Procedure II, III | 507.3/Procedure II, III | 507.4 |
| Salt Fog | 509.1/Procedure I | 509.2/Procedure I | 509.3/Procedure I | 509.4 |
| Dust | 510.1/Procedure I | 510.2/Procedure I | 510.3/Procedure I | 510.4/Procedure I, III |
| Vibration | 514.2/Procedure VIII, X | 514.3/Procedure I | 514.4/Procedure I | 514.5/Procedure I |
| Shock | 516.2/Procedure I, II, V | 516.3/Procedure I, IV | 516.4/Procedure I, IV | 516.5/Procedure I, IV |
| International Protection Standard | ||||
| Dust & Water Protection *2 | IP54/55 | |||
*1 To meet the blowing-rain condition, the 2-pin connector cover has to be connected on the radio.
*2 To meet IP54/55, the 2-pin connector cover has to be connected on the radio;
the locking bracket has to be attached to the KMC-45 external speaker microphone.
