NX-1200/1300

SPECIFICATIONS

General NX-1200 NX-1300
Pre-set Frequencies Type 1 136-174 MHz
Type 2 400-470 MHz
Max. Channels per Radio 260 (64 for basic model)
Number of Zones 128 (4 for basic model)
Max. Channels per Zone 250 (16 for basic model)
Channel Spacing Analog 30 / 25 / 15 / 12.5 kHz
Digital 12.5 / 6.25 kHz
Power Supply 7.5 VDC ±20 %
Battery Life DMR Analog/NXDN
KNB-45L (2000mAh) Approx. 14.5 hours Approx. 11 hours
KNB-69L (2550mAh) Approx. 19 hours Approx. 14 hours
Operating Temperature(Radio only)*1 -22°F to +140°F (-30°C to +60°C)
Frequency Stability (-30 to +60°C; +25°C Ref.) ±0.5 ppm
Antenna Impedance 50 Ω
Dimensions (W x H x D) Projections Not Included
Radio with KNB-45L 2.13 x 4.84 x 1.32 in (54 x 123 x 33.5 mm)
Radio with KNB-69L 2.13 x 4.84 x 1.48 in (54 x 123 x 37.5 mm)
Weight Radio Only 6.17 oz (175 g)
Radio with KNB-45L 10.41 oz (295 g)
Radio with KNB-69L 10.93 oz (310 g)
IC Certification 282F-501000 282F-501100
Receiver NX-1200 NX-1300
Sensitivity NXDN® @ 6.25 kHz Digital (3% BER) 0.18 μV
NXDN® @ 12.5 kHz Digital (3% BER) 0.22 µV
DMR® @ 12.5 kHz Digital (1% BER) 0.25 µV
DMR® @ 12.5 kHz Digital (5% BER) 0.18 µV
Analog @ 12.5/25 kHz (12 dB SINAD) 0.24 µV / 0.20 µV
Selectivity Analog @ 12.5 / 25 kHz 68 dB / 74 dB
Intermodulation Distortion 70 dB
Spurious Rejection 70 dB
Audio Distortion 7%
Audio Output Power 1 W / 12 Ω (Internal Output)
Transmitter NX-1200 NX-1300
RF Power Output (High / Low) 5 W / 4 W / 1 W 5 W / 4 W / 1 W / .25 W
Spurious Emission -70 dB
FM Hum & Noise Analog @ 12.5 / 25 kHz 40 dB / 45 dB
Audio Distortion 2%
DMR Digital Protocol ETSI TS 102 361-1, -2, -3
Emission Designator 16K0F3E, 11K0F3E, 8K30F1E, 8K30F1D, 8K30F7W, 4K00F1E, 4K00F1D, 4K00F7W, 4K00F2D, 7K60FXD, 7K60F7W

*1 Operating temperature specification for a Li-ion battery is -10°C to +60°C [14°F to +140°F].Analog measurements made per TIA603. Specifications are measured according to applicable standards.Specifications are subject change without notice, due to advancements in technology.

FleetSync® is a registered trademark of JVCKENWOOD Corporation in the United States and/or other countries.NXDN® is a trademark of JVCKENWOOD Corporation and Icom Inc.NEXEDGE® is a registered trademark of JVCKENWOOD Corporation.All other trademarks are the property of their respective holders.

MIL-STD & IP

MIL Standard MIL 810C Methods/Procedures MIL 810D Methods/Procedures MIL 810E Methods/Procedures MIL 810F Methods/Procedures MIL 810G Methods/Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II 500.5/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II 501.5/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II 502.5/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II 503.5/Procedure I
Solar Radiation 505.1/Procedure 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I 505.5/Procedure I
Rain* 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III 506.5/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4 507.5/Prcedure II
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4 509.5
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III 510.5/Procedure I
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I 514.6/Procedure I
Shock 516.2/Procedure I, II, V 516.3/Procedure I, IV 516.4/Procedure I, IV 516.5/Procedure I, IV 516.6/Procedure I, IV
International Protection Standard
Dust & Water Protection* IP54/55* To meet IP54/55, the 2-pin connector cover has to be connected on the radio or the locking bracket has to be attached to the external speaker microphone.