Support

TK-2312/3312

  TK-2317 TK-3317
GENERAL
Frequency Range 136 - 174 MHz (Type 1,2) 450 - 520 MHz (Type 1,3)
400 - 470 MHz (Type 2,4)
Number of Channels / Zones 128 / 128
Channel Spacing Wide / Narrow 25 / 12.5 kHz
Operating Voltage 7.5 V DC ±20 %
Battery Life (5-5-90 duty cycle, save off / on) with KNB-45L (2000 mAh) Approx. 12 hours / Approx. 18 hours
with KNB-53N (1400 mAh) Approx. 9 hours / Approx. 12 hours
with KNB-29N (1500 mAh) Approx. 10 hours / Approx. 14 hours
Operating Temperature Range -30°C ~ +60°C
Frequency Stability ±2.5 ppm (-30°C ~ +60°C)
Antenna Impedance 50 Ω
Channel Frequency Spread 38 MHz 70 MHz
Dimensions (W x H x D), Projections not Included Radio only 54 x 122 x 21 mm
with Battery 54 x 122 x 33.7 mm
Weight (net) Radio only Approx. 180 g
with KNB-45L Approx. 300 g
with KNB-53N Approx. 365 g
with KNB-29N Approx. 380 g
FCC ID Type 1 ALH413700 ALH413800
Type 2 ALH413801
FCC Compliance Parts 22 / 74 / 90 Parts 22 / 74 / 90
Australia / New Zealand AS / NZS 4295
RECEIVER
Sensitivity (12 dB SINAD) Wide / Narrow 0.25 μV / 0.28 μV
Selectivity Wide / Narrow 70 dB / 60 dB
Intermodulation Distortion Wide / Narrow 70 dB / 60 dB
Spurious Response 70 dB
Audio Distortion Less than 5 %
Audio Output 500 mW / 8 Ω
TRANSMITTER
RF Output Power (High / Low) 5 W / 1 W
Spurious Response 70 dB
FM Hum & Noise Wide / Narrow 45 dB / 40 dB
Audio Distortion Less than 5 %
Modulation Wide / Narrow 16K0F3E / 11K0F3E

Measurements made per TIA/EIA 603 and specifications shown are typical.
Specifications are subject to change without notice, due to advancements in technology.
FleetSync® is a registered trademark of JVC KENWOOD Corporation.

Applicable MIL-STD & IP

Standard MIL 810C
Methods/
Procedures
MIL 810D
Methods/
Procedures
MIL 810E
Methods/
Procedures
MIL 810F
Methods/
Procedures
MIL 810G
Methods/
Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II 500.5/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II 501.5/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II 502.5/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II 503.5/Procedure I
Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I 505.5/Procedure I
Rain 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III 506.5/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4 507.5/Procedure II
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4 509.5
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III 510.5/Procedure I
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I 514.6/Procedure I
Shock 516.2/Procedure I, II, V 516.3/Procedure I, IV 516.4/Procedure I, IV 516.5/Procedure I, IV 516.6/Procedure I, IV
International Protection Standard
Dust & Water Protection IP54
IP55